FAQ

PHONE: 800-497-4376| 828-687-0215FAX: 828-687-0182

FAQ

If you have a question we don't address, please call or eMail us today:

ResinArt East:800-497-4376 or Doug@Resinart.com

Question:
Do I need to order DuraFlex Moulding preformed to match a curve or do we order it straight and form it on the job?
Answer:
You will need to order the material preformed to match a curve. Imagine taking a belt and laying it flat on a wall and then trying to bend the ends down toward the floor to create an arch, the belt will buckle and so would our moulding. Radius graphYet the same belt will wrap around something easily, the same is true of our DuraFlex Moulding.

For 1/2 round windows or openings the measurement we need is the RADIUS and the width of the base of the opening. The radius is the distance between the mid-point of the base line and the edge of the 1/2 round opening.

For arched door entries and other arched openings, we will need two measurements; WIDTH and RISE. The width is the widest distance at the base of the arch and the rise is the largest distance between the base and the top of the arch. To help calculate this, please use our online RADIUS CALCULATOR. For Elliptical windows, please provide us with a template.

Question:
How do I calculate the footage of DuraFlex Moulding material needed for a RADIUS or ARCH opening?
Answer:
If opening is true 1/2 round, like the RADIUS shown above, add the width of the casing to the radius and multiply by 3.146 and divide by 12, then round up to the nearest foot. If the opening is an ARCH (segment head) add the width of the opening and the rise in the center of the arch and add 12 inches, then round up to the nearest foot.

Question:
How do I stain DuraFlex Mouldings?
Answer:
The use of water base stains such as Minwax work well. Apply with brush or rag and wipe off. Additional coats may be applied if necessary to match the wood. Be sure to allow first coat to dry completely before applying more stain.

Question:
Is DuraFlex Moulding temperature sensitive?
Answer:
DuraFlex Moulding is a poly-urethane based product and is less flexible when cold. Before installing allow DuraFlex to reach room temperature above 60 degrees. F.

Question:
Can you use DuraFlex Moulding for Exterior applications?
Answer:
YES! All DuraFlex Mouldings are suitable for external use.

Question:
Can DuraFlex Mouldings be nailed and glued like regular wood mouldings?
Answer:
YES! The use of polyurethane construction adhesive behind and at miter joints in addition to pneumatic pin nailing is recommended. Nails should be kept 6" apart and 3/8" for any edge. Pre-drilling is not necessary when using #6 or smaller finish nails. Some installers use only glue adhesives and no nails at all.

Question:
Can DuraFlex Mouldings be cut, shaped or sanded like wood mouldings?
Answer:
YES! DuraFlex can be cut, shaped or sanded using standard woodworking equipment. However, if a wood grain is on the moulding, sanding will remove the wood grain finish.

Question:
I have a custom moulding profile, can you match this in DuraFlex Moulding?
Answer:
YES! Just send us 14' of the wood moulding you need in flex and we will create a DuraFlex Moulding to match. Please see our custom orders page for more details.

Question:
Can you send us some more information on DuraFlex Mouldings?
Answer:
Sure... just fill out our Contact US form and request more information in the comments box and we'll send you more information right away.